Modular Plastic Floats

Suitable for DIY construction of pontoon boats and mobile house boats

Modular Float System PT01

Suitable for the construction of pontoon boats or small house boats with medium payloads

• description and specifics

  The modular float system PT01 is especially suitable for DIY-construction of pontoon boats and small mobile house boats or pontoon rafts. The modular pontoon sections can be plugged together by dovetail guide. Therefore, the length of the pontoon hull is variable. For the construction of a pontoon tube, one front section, any number of middle sections and, if desired, one end section are required. By means of the into the floats embedded metal threads it's possible to screw a keel ledge at the hull underside and a support frame at the top side. The supporting frame can be made of wood, plastic or metal depending on required stiffness of the floating platform. An attached keel ledge (e.g. solid plastic profile) under the pontoon hull enhances the stability of the hull as well as the manoeuvrability of your pontoon boat or houseboat.

  Special Features

  The front section of the PT01 pontoon system can be modified. A bow thruster or side thruster can be installed.

  We will be happy to advise you on the phone or by e-mail. Just give us a call, use our callback service or the contact form.

Individual components / pontoon modules

PT01 end section
☰ data sheet-PT01 end section

PT01 middle section
☰ data sheet-PT01 middle section

PT01 front section☰ data sheet-PT01 front section

PT01 front section with tunnel☰ data sheet-PT01 front section with tunnel

Possible hull forms

hull form 1: with front-section and end-section

hull form 2: with front-section but without end-section

hull form 3: with 2x front-section 

General installation instructions

attaching the keel-ledge

attaching the support frame (with lower stiffness)

attaching the support frame (with higher stiffness)

price inquiry PT01 float system

Modular Float System PT06

Suitable for the construction of pontoon boats or larger house boats with high payloads

• description and specifics

  The modular float system PT06 is ideally suited for DIY-construction of house boats and pontoon raftss. The individual floats can be plugged together by a tongue and groove system. Therefore, the length of the pontoon hull is variable. For the construction of a pontoon tube, one front section, any number of middle sections and, if desired, one end section are required. By means of the into the floats embedded metal threads it's possible to screw a keel ledge at the hull underside and a support frame at the top side. The supporting frame can consist of wood, plastic or metal depending on required stiffness of the floating platform. An attached keel ledge (e.g. solid plastic profile) under the pontoon hull enhances the stability of the hull as well as the manoeuvrability of your pontoon boat or houseboat.

  Special Features

  Some individual pontoon floats of the PT06 pontoon system can be modified in various ways.
  PT06 middle section: conversion to fresh water tank or waste water tank possible
  PT06 middle section with tunnel: installation of a bow thruster or side thruster possible

  We will be happy to advise you on the phone or by e-mail. Just give us a call, use our callback service or the contact form.

Individual components / pontoon modules

PT06 end section☰ data sheet-PT06 end section

PT06 middle section☰ data sheet-PT06 middle section

PT06 middle sec. with tunnel☰ data sheet-PT06 middle section with tunnel

PT06 front section☰ data sheet-PT06 front section

Possible hull forms

hull form 1: with front-section and end-section

hull form 2: with front-section but without end-section

General installation instructions

attaching the keel-ledge

attaching the support frame (with lower stiffness)

attaching the support frame (with higher stiffness)

price inquiry PT06 float system